ADVANCE RESERVATION - GE Dash 9-44CW Locomotive - Santa Fe Warbonnet

Scaletrains

SXT-SFDCCREADY

New product

Available To Pre-Order

£ 190.00

Add to wishlist

THIS IS AN ADVANCE RESERVATION - ETA SUMMER 2019.

ESTIMATED PRICE - AS A GUIDE ONLY - BASED ON CURRENT COSTS ETC - £190.00. YOU ARE ONLY CHARGED WHEN THE MODELS HAVE BEEN DELIVERED. IF THE FINAL PRICE IS 10% MORE THAN OUR ESTIMATE WE WILL CONTACT YOU BEFORE WE CHARGE.YOU WILL OF COURSE PAY A LOWER PRICE SHOULD OUR COST REDUCE.

PAY A MINIMUM DEPOSIT OF 10% OF OUR ESTIMATED PRICE AND UPGRADE TO A 15% DISCOUNT OFF OUR FINAL SHELF PRICE - NORMALLY 10%. SEE "DISCOUNT SCHEMES" FOR FULL DETAILS.

IF YOU WISH TO PAY A DEPOSIT MAKE A NOTE IN THE ORDER COMMENTS BOX AT CHECKOUT.

THERE ARE 6 ROADNUMBERS AVAILABLE FOR THIS MODEL ALL WITH DETAIL DIFFERENCES. PLEASE REFER TO THE SCALETRAINS WEB SITE FOR FURTHER INFORMATION.

THE REFERENCE NUMBERS/RUNNING NUMBERS ARE AS FOLLOWS - SXT31305 - #600, SXT31307 - #607, SXT31309 - #642, SXT31311 - #653, SXT31313 - #666 and SXT31315 - #699.

PLACE YOUR SELECTION IN THE ORDER COMMENTS BOX. THE PRICE QUOTED IS FOR ONE MODEL.

1st run road numbers (announced January 2019): 600, 607, and 642
◾Era: as delivered, series 600-611, built 2-3/1994
◾Era: as delivered, series 612-642, built 2-3/1994
◾One-piece nose top grab irons
◾Early Hi-Ad trucks with reinforcement bulge and non-cantilevered struts on all four sideframes
◾Large Sinclair “ice skate” communication antenna and small Sinclair “ice skate” End Of Train (EOT) telemetry antenna

1st run road numbers (announced January 2019): 653, 666, and 699
 ◾Era: as delivered, series 650-699, built 8-9/1994
◾Two-piece nose top grab irons
◾Late Hi-Ad trucks with non-cantilevered struts on all four sideframes
◾Large Sinclair “ice skate” communication antenna, small Sinclair “ice skate” End Of Train (EOT) telemetry antenna and small “cone” antenna

All Santa Fe road numbers also include :
◾Operating pilot-face mounted LED ditch lights - DCC ONLY
◾Small snowplow with open doors
◾4-step see-through stepwells
◾Wide profile end handrails
◾GE safety cab with “gull-wing” roof profile and three (3) side windows
◾Low headlight
◾Nose door with window
◾Motive Equipment Inc. (MEI) ME7000 HVAC Unit
◾Early (curved) engine cab profile
◾Lost-wax brass Leslie RS-3L horn mounted on engine cab
◾Early flanged exhaust stack housing
◾Early lifting lugs on ends of radiator wings
◾High-mounted rear sandfiller
◾Separate air tanks with upper mounting brackets
◾Dual fuel fills per side with rear fill “blanked”
◾Spare coupler knuckle holders on truck sideframes

These The Rivet Counter DASH 9-44CW Locomotives Also Feature :
◾All-new model
◾ *NEW* Operating front, rear, and side LED walkway lights - DCC ONLY
◾Fully-assembled
◾Printed and LED lighted number boards
◾Dayton Phoenix (DPG) Model 280620 or Motive Equipment (MEI) ME7000 HVAC Units
◾Hi-Ad trucks with separately applied brake cylinders, air plumbing, and struts (per prototype) ◾Early with reinforcement bulge
◾Late with cantilever struts on right front and left rear sideframes
◾Late with non-cantilevered struts on all four sideframes
◾Late with cantilever struts on all four sideframes
◾Rotating axle bearing caps
◾Nose door with or without window
◾Four (4) step or five (5) step see-through stepwells
◾Narrow or wide profile end handrails
◾One or two-piece nose top grab iron(s)
◾Early (curved) or late (angled) engine cab profile
◾Early flanged or late non-flanged exhaust stack housing
◾Early or late lifting lugs on ends of radiator wings
◾Low or high rear sand filler
◾Separate air tanks with lower or upper mounting brackets
◾Three (3) types of fuel fills per side: single; dual; dual with rear fill blanked
◾Spare coupler knuckle holders on truck sideframes or rear pilot face
◾GE “nub” pattern walkway tread
◾Accurately profiled frame with separately applied plumbing and traction motor cabling
◾Detailed cab interior with separate floor, rear wall, seats, and desktop controls or control stand, per prototype
◾Tinted cab side windows
◾26 individually-applied etched metal see-through radiator intake and exhaust grilles on sides and top of radiator compartment
◾“Bathtub” exhaust silencer
◾5,000-gallon fuel tank
◾Factory-applied detail parts: wire grab irons, snowplow, spare knuckles, trainline hoses, 3-hose MU clusters, uncoupling levers, windshield wipers, mirrors, sunshades, air tanks, fuel tank mounted steel bell (unless noted), brake wheel and more
◾Semi-scale coupler buffer
◾Durable metal semi-scale Type E knuckle couplers
◾Motor with 5-pole skew wound armature
◾Dual flywheels
◾All-wheel drive
◾All-wheel electrical pick-up
◾Directional LED headlights
◾Printing and lettering legible under magnification
◾Operates on Code 70, 83, and 100 rail
◾Packaging safely stores model
◾Minimum Radius: 18”
◾Recommended Radius: 22”

These DCC & sound ready locomotives also feature:
◾Operate on DC layouts
◾DCC ready with 21-pin connector

No customer reviews for the moment.

Write a review

ADVANCE RESERVATION - GE Dash 9-44CW Locomotive - Santa Fe Warbonnet

ADVANCE RESERVATION - GE Dash 9-44CW Locomotive - Santa Fe Warbonnet

Other products in the same category: